(To be removed) Implement baseband phase-locked loop
Baseband PLL will be removed in a future release. To design voltage-controlled oscillators (VCOs) and phase-locked loops (PLLs), use the Phase-Locked Loops (Mixed-Signal Blockset) blocks.
Components sublibrary of Synchronization
The Baseband PLL (phase-locked loop) block is a feedback control system that automatically adjusts the phase of a locally generated signal to match the phase of an input signal. Unlike the Phase-Locked Loop block, this block uses a baseband method and does not depend on a carrier frequency.
This PLL has these three components:
An integrator used as a phase detector.
A filter. You specify the filter's transfer function using the Lowpass filter numerator and Lowpass filter denominator parameters. Each is a vector that gives the respective polynomial's coefficients in order of descending powers of s.
[num, den] = cheby2(3,40,100,'s')
A voltage-controlled oscillator (VCO). You specify the sensitivity of the VCO signal to its input using the VCO input sensitivity parameter. This parameter, measured in Hertz per volt, is a scale factor that determines how much the VCO shifts from its quiescent frequency.
This block accepts a sample-based scalar signal. The input signal represents the received signal. The three output ports produce:
The output of the filter
The output of the phase detector
The output of the VCO
This model is nonlinear; for a linearized version, use the Linearized Baseband PLL block.
For more information, Phase-Locked Loops.
The numerator of the lowpass filter's transfer function, represented as a vector that lists the coefficients in order of descending powers of s.
The denominator of the lowpass filter's transfer function, represented as a vector that lists the coefficients in order of descending powers of s.
This value scales the input to the VCO and, consequently, the shift from the VCO's quiescent frequency.